All articles

Pre-Colored Press On's: How to Prime, Print & Seal on Pre-Colored Press-On'sUpdated 2 years ago

Here is how to Prime, Print, and Seal on Pre-Colored Press-On's.


- Following the directions on your Press-On Nail Box, apply your press-on to your nails.


- Open Primer and gently wipe off excess primer from the brush - Only a minimal amount of primer is needed on the nail for printing.

- Apply one thin layer of primer over the nail bed

  • - If you apply too thick of a layer of primer, the top coat will not be able to penetrate the primer to turn it transparent. 

- Primer will dry to a chalky white matte finish.

  • - Primer should dry in about 2 minutes. - Primer takes longer to dry on Press-On Nails than natural nails.


- Insert your finger into the Nailbot and rest on the Finger Cradle

- Print your selected Nailbot design

  • - If you are unhappy with your print, you can remove your design with an alcohol wipe, reprime, and reprint


- Apply one layer of top coat over the whole nail bed to lock in your print.

- Apply a second layer of top coat over the colored polish to ensure all primer has disappeared.

- Your nails are now ready to be shown off!

Was this article helpful?